Volume 40, Issue 3 pp. 288-297
Special Issue Paper

Fabrication of PDMS-based triboelectric nanogenerator for self-sustained power source application

So-Yoon Shin

So-Yoon Shin

Nanomaterials and System Lab, Department of Mechatronics Engineering, Engineering College, Jeju National University, Jeju, 690-756 Republic of Korea

These authors contributed equally.Search for more papers by this author
Balasubramaniam Saravanakumar

Balasubramaniam Saravanakumar

Nanomaterials and System Lab, Department of Mechatronics Engineering, Engineering College, Jeju National University, Jeju, 690-756 Republic of Korea

These authors contributed equally.Search for more papers by this author
Ananthakumar Ramadoss

Ananthakumar Ramadoss

Nanomaterials and System Lab, Faculty of Applied Energy System, Science and Engineering College, Jeju National University, Jeju, 690-756 Republic of Korea

Search for more papers by this author
Sang Jae Kim

Corresponding Author

Sang Jae Kim

Nanomaterials and System Lab, Department of Mechatronics Engineering, Engineering College, Jeju National University, Jeju, 690-756 Republic of Korea

Nanomaterials and System Lab, Faculty of Applied Energy System, Science and Engineering College, Jeju National University, Jeju, 690-756 Republic of Korea

School of Materials Science and Engineering, Georgia Institute of Technology, Atlanta, GA, 30332-0245 USA

Correspondence

Sang Jae Kim, Nanomaterials and System Lab, Department of Mechatronics Engineering, Engineering College, Jeju National University, Jeju 690-756, Republic of Korea.

E-mail: [email protected]

Search for more papers by this author
First published: 07 August 2015
Citations: 54

Summary

In this report, we present a simple approach to fabricate the polydimethylsiloxane (PDMS)-based triboelectric nanogenerator (TENG) that can be effectively harvest irregular mechanical energy and the energy used to drive a small commercial electronic component. The device exhibited the maximum open-circuit voltage and short-circuit current of 6.3 V and 0.635 μA respectively, with maximum output power of 178 nW. In addition, we measured the performance of the fabricated device with different load resistance. Finally, the fabricated PDMS-based triboelectric nanogenerator can directly drive 10 commercial LEDs connected in series, when the force is applied to the device through finger. These results demonstrate the potential application of PDMS-based triboelectric nanogenerator for self-powered systems. Copyright © 2015 John Wiley & Sons, Ltd.

The full text of this article hosted at iucr.org is unavailable due to technical difficulties.