Morphology and flow effect of microinjection-molded plastic microgears

Corresponding Author

Rabie El Otmani

• [email protected]

National School of Applied Sciences (ENSAJ), Science Engineer Laboratory For Energy (LabSIPE), Chouaib Doukkali University of El Jadida, Route nationale No. 1 (route d'Azemmour), km 6 Azemmour EL HAOUZIA, BP: 1166 El Jadida Plateau, El Jadida, 2400 Morocco

Correspondence to: Rabie El Otmani, Chouaib Doukkali University of El Jadida, National School of Applied Sciences (ENSAJ), Science Engineer Laboratory For Energy (LabSIPE), Route nationale No. 1 (route d'Azemmour), km 6 Azemmour EL HAOUZIA, BP: 1166 El Jadida Plateau 2400, Morocco.

E-mail: [email protected]

E-mail: [email protected]

Search for more papers by this author

Khalid Kandoussi

National School of Applied Sciences (ENSAJ), Science Engineer Laboratory For Energy (LabSIPE), Chouaib Doukkali University of El Jadida, Route nationale No. 1 (route d'Azemmour), km 6 Azemmour EL HAOUZIA, BP: 1166 El Jadida Plateau, El Jadida, 2400 Morocco

Search for more papers by this author

Musa R. Kamal

Department of Chemical Engineering, McGill University, Montreal, QC, Canada

Search for more papers by this author

Salim Derdouri

National Research Council, Boucherville, QC, Canada

Search for more papers by this author

M'Hamed Boutaous

CETHIL, UMR 5008, CNRS, INSA Lyon, Université Lyon 1, F-69621 Villeurbanne CEDEX, Lyon, France

Search for more papers by this author